contestada

your routers have been configured to use eigrpv6. while troubleshooting a routing issue, you decide that you need to view successor information on each router. which command should you use to do this? answer show ipv6 eigrp neighbors show ipv6 route show ipv6 eigrp interfaces show ipv6 eigrp topology show ipv6 protocols

Respuesta :

tutorconsortium125

Show ipv6 eigrp neighbors

         EIGRP for IPv6 is directly configured on the interfaces over which it runs. This feature allows EIGRP for IPv6 to be configured without the use of a global IPv6 address.

What is IPv6 ?

     Internet Protocol version 6 is the most recent version of the Internet Protocol, the communications protocol that provides an identification and location system for computers on networks and routes traffic across the Internet. The Internet Engineering Task Force (IETF) created IPv6 to address the long-anticipated problem of IPv4 address exhaustion, and it is intended to replace IPv4. IPv6 became a Draft Standard for the IETF in December 1998, and it was ratified as an Internet Standard on July 14, 2017.  The successor protocol had been formalised by the IETF by 1998. IPv6 uses 128-bit addresses, with a total address space of 2128, or approximately 3.41038. The actual number is slightly lower because several ranges are reserved for special use or are completely off-limits. Because the two protocols are not intended to be interoperable, direct communication between them is impossible, complicating the transition to IPv6. However, several transition mechanisms have been developed to address this issue.

             In addition to a larger addressing space, IPv6 offers other technical advantages. It specifically allows hierarchical address allocation methods, which facilitate route aggregation across the Internet and thus limit routing table expansion. The use of multicast addressing is expanded and simplified, providing additional service delivery optimization. The protocol's design took device mobility, security, and configuration into account.

To learn more about IPv6  refer :

https://brainly.com/question/28901631

#SPJ4

tutorconsortium127

EIGRP for IPv6 is directly configured on the interfaces over which it runs. This feature allows EIGRP for IPv6 to be configured without the use of a global IPv6 address.

What is IPv6 ?

  • Internet Protocol version 6 is the most recent version of the Internet Protocol, the communications protocol that provides an identification and location system for computers on networks and routes traffic across the Internet.
  • The Internet Engineering Task Force (IETF) created IPv6 to address the long-anticipated problem of IPv4 address exhaustion, and it is intended to replace IPv4. IPv6 became a Draft Standard for the IETF in December 1998, and it was ratified as an Internet Standard on July 14, 2017.
  • The successor protocol had been formalised by the IETF by 1998. IPv6 uses 128-bit addresses, with a total address space of 2128, or approximately 3.41038. The actual number is slightly lower because several ranges are reserved for special use or are completely off-limits.
  • Because the two protocols are not intended to be interoperable, direct communication between them is impossible, complicating the transition to IPv6. However, several transition mechanisms have been developed to address this issue.
  • In addition to a larger addressing space, IPv6 offers other technical advantages. It specifically allows hierarchical address allocation methods, which facilitate route aggregation across the Internet and thus limit routing table expansion.
  • The use of multicast addressing is expanded and simplified, providing additional service delivery optimization. The protocol's design took device mobility, security, and configuration into account.

To learn more about IPv6  refer to:

brainly.com/question/28901631

#SPJ4